BLHeli_32 is the third generation BLHeli code, following base BLHeli and BLHeli_S.
BLHeli_32 runs on an ARM 32bit MCU, initially it will be on a Cortex-M0 running at 48MHz, but there are MCUs out there that can run a lot faster.
This ESC has a 2200uf cap on board and uses a digital current sensor. The digital current sensor provides more precision and eliminates drift. It also doesn't require the 0.5 mohm resistor in the circuit, reducing any power loss and offer more power overall.
An extreme ESC for extreme pilots!
- 60A continuous current support with bursts up to 80A
- Supports up to 6S lipo
- The metal MOS has a better heat dissipation and gives more power.
- More capacitors, including a 2200uf one.
- Better power supply lines
- Better stability.
- Better transmission interface layout
What is new with V2
The new version 2 is a tweaked design that makes the Wraith 32 metal even more extreme. This version include an extra 2200uf capacitor to further filter any noise. It also now uses a digital current sensor. Why use a digital current sensor you may ask? Well the digital sensor is more precise and elmiates drift. It also means that you dont need to use a 0.5 ohm resistor in the circuit that reduces any power losses, giving this ESC more power overall to send to your motors!
- Build in digital current sensor
- BLheli32 Firmware
- On-Board RGB LED
- 2-6s LIPO input
- 60A designed