BOLTRC Black Ops V2 Regular 7 inch Frame Kit (BOPSV2R7GT)

$139.95

We currently have 1 left in stock.
Quantity
Add to Wishlist
Hours, Mins, Seconds Until Next Despatch
Order Before 1PM AEST (Weekdays) For Same Day despatch.

Product Details

This is our new Black Ops frame designed to be flown anywhere and take an absolute beating.

This is the regular version (30mm high standoffs) with 7in arms made from thicker 5mm foam core sheet. This is the same amazing foam core we developed for our Kraken WORX frames.

The R version also includes the newer aluminium fpv cam mount solution. 

The BOPS is the freestyle frame of choice for both Webb and Juz. Its also the frame newbies can get started with.

Key features are:

Extensive integrated bumper protection system, top and bottom, front and rear.
Regular Edition - 30mm profile for regular size fpv cams.
Innovative structural system and component layout
High quality components inlcuding 7075 aluminium standoffs
Integrated LED system
Integrated XT60 Connector
Low Profile PDB
Integarted 1000uF capacitor
Stainless steel inset arm mount system

Package Contents

Top Plate - 2.0mm
Upper Bottom Plate - 1.5mm
Lower Bottom Plate - 2.0mm
Top Front Bumper - 2.0mm
Top Rear Bumper - 2.0mm
Bottom PC Front Bumper - 5.0mm
Bottom PC Rear Bumper - 5.0mm
Bottom PC Side Bumpers  - 5.0mm
Custom BOLT PDB
Die cut neoprene foam rubber battery pad for the top plate
7in Arms - 5mm thick foam core sandwich
Rear Vertical PDB
Vertical rear spine - 1.5mm
XT60PW
1000uF 35v Capacitor
BOLT 300x25mm Battery Stap

Hardware Kit including

M3x30 7075 Orange Alu Standoffs - 3pcs
M3x30 Rear slotted 6061 standoff - 2pcs

Pad Kit
Small black zip tie (same as other kit) 1.8x100mm - 10pcs
Large black zip tie (same as other kit) 35x350mm - 4pcs
3M double sided tape - 1.2mmx20mmx100mm - 1pc

The frame does not include motor mount screws or washers. Only ships with RED rear LEDs.  Extra LEDs are available for purchase.

Build Comments

As these vertical CF plates are integral to the design, we have kept the tolerances as tight as we can. Accordingly, some sanding of the tabs for the vertical plates may be required to fit into the slots. Please avoid oversanding for a sloppy fit. Always include the vertical plates and bumpers in your build, they are a key structural design feature.

The battery strap MUST go around the entire frame body and not just the top plate. This is a key design feature which clampts the two plates togther with the vertical plates. We recommend the longer BOLT battery straps (30cms) for this reason.

Recommended Components

All electronics, wiring, motors and props are not included and can be purchased separately. Please note that the Regular version is specifically designed to take a full size FPV including the RC Swift and Foxeer Arrow.  The cam plates are adjustable by 0.3mm each side to take both 28mm and 28.6mm wide cameras. The alu plates can alos moves forward and aft by 3-4mm to adjust for smaller and larger lenses.

If using the HS1177, you will need to drill the centre hole to a large diameter. We recommend using a more modern camera case than the HS1177 to avail yourself of the 4 point mount solutions. 

Build Instructions

https://boltrc.freshdesk.com/solution/folders/9000182718